Grex P6/Mp-3 23 Gauge Multi-Pack Headless Pins (3,000 Per Box) by Grex Power Tools

Product Information

The P6 Series comes in seven different designs: P630, P635, P645, P645L, P650, P650L and the P650LX. I just did a pre-finished crown job and used one 1" 23 gauge pin in each end of pre-finished buff colored crown run of 6 feet simply to hold molding while Loctite hi grab adhesive set up.

The comments below were added after this Forum discussion was archived as a Knowledge Base article ( add your comment). Used for general repairs, trim/molding and picture framing, the 23-gauge Arrow Pin Nails are the thinnest and shortest (3/8” and 1/2") of all finishing nails.

Once a satisfactory joint is achieved the last pieces are glued and nailed to the legs, cabinet, and ceiling if necessary. Locktite is great for this against ceilings and flat cabinet faces but requires a gap so it doesn’t work too well for ends/miters. I will glue up the joints with a combination of urethane glue and an Elmers or Titebond type of glue being very careful about the spread and quantity avoiding squeeze-out and urethane expansion to minimize clean up.

Introducing the HiKOKI NP18DSALW4Z 18V 23G Cordless Pin Nailer Bare Unit, a lightweight and compact tool that is perfect for both trade professionals and DIY enthusiasts. They are packed 10,000 to a plastic storage case and available in 7 lengths of 12, 18, 25, 30, 35, 40 and 50mm. Pins tend to be headless and of a tiny gauge (diameter), which is not ideal for applications where holding power is needed. The extremely fine gauge of the pins makes them ideal for secrete nailing where you do not want the nail exposed.We supply coil nails, framing nails, brad nails for leading brands of nails guns in Paslode, Spit, Pulsa, TJEP, Omer, DeWalt, Senco, BeA, Milwaukee, Prebena. I need some way to hold half the pieces upright and in-place while I draw marking lines and take measurements.